Garmin Autopilots installation
Garmin Marine Autopilots | Supply & Installation
Garmin marine autopilots are a solid choice for Aussie boaties who want smooth, reliable steering without riding the wheel all day. Whether you’re trolling for pelagics, cruising the coast or heading wide offshore, a properly set-up Garmin autopilot takes the hard work out of staying on course.
Shotgun Marine supplies and installs Garmin autopilot systems in Port Macquarie and across the Mid North Coast NSW. We’re authorised installers — which means we don’t just bolt gear on, we size it correctly, wire it cleanly and tune it properly for real conditions.
Garmin autopilot supply & installation
Garmin autopilots work alongside heading sensors, chartplotters and steering systems to hold a course, follow routes and maintain steady trolling lines. We assess your boat’s size, weight and steering type before recommending the right Garmin autopilot package — no guesswork.
These systems integrate cleanly with Garmin multifunction displays and onboard networks, allowing route steering and accurate heading control when everything’s set up correctly.
Integration & commissioning that actually works
Autopilots only perform as well as the install behind them. We handle power supply, networking, drive sizing and calibration, then commission the system so it steers smoothly in swell, wind and current — not just on flat water.
- Garmin autopilot system supply and fit
- Heading sensor selection and placement
- Integration with Garmin chartplotters and MFDs
- NMEA 2000 network setup and diagnostics
- Calibration and sea-trial tuning
If you’re upgrading an older system or fitting a new boat, we’ll make sure your Garmin autopilot is installed properly and backed by local support.
Garmin Autopilot FAQs
What size Garmin autopilot do I need?
Autopilot size depends on your boat’s length, displacement and steering type. Smaller boats can use compact systems, while heavier offshore boats need higher-capacity drives. We assess this before recommending anything.
Do Garmin autopilots integrate with chartplotters?
Yes. Garmin autopilots integrate with compatible Garmin chartplotters, allowing route following, heading hold and steering from the screen when set up correctly.
Is a heading sensor required?
Absolutely. A heading sensor gives the autopilot accurate direction data, resulting in smoother steering and better performance in changing conditions.
Are Garmin autopilots suitable for offshore use?
Yes — when installed and calibrated properly. Garmin autopilots are designed to handle swell, current and wind when matched to the right boat and steering system.
Do you install Garmin autopilots in Port Macquarie?
We sure do. Shotgun Marine supplies and installs Garmin autopilots in Port Macquarie and throughout the Mid North Coast NSW, including full setup and commissioning.
