B&G Multifunction Display
B&G Multifunction Displays – Built for Sailing
B&G multifunction displays are designed specifically for sailing. Unlike general-purpose chartplotters, B&G displays focus on accurate wind data, clear sailing layouts, and seamless integration with instruments, autopilots and sensors that matter when you’re under sail.
At Shotgun Marine, we install and configure B&G MFDs so they actually perform the way they’re meant to — offshore, under load, and in real sailing conditions.
What Makes B&G Displays Different
B&G multifunction displays are built around sailing needs, not powerboat shortcuts. When set up properly, they give you:
-
Clear charting and navigation views
-
Dedicated sailing pages for wind, laylines and VMG
-
Fast, reliable screen response at the helm
-
Seamless integration with B&G instruments and autopilots
From coastal cruising to offshore passages, B&G displays give skippers the information they need without clutter or confusion.
B&G Displays We Install & Configure
We work with the full range of B&G multifunction displays, including:
-
B&G Zeus series displays
-
Helm and nav-station display setups
-
Multi-screen sailing systems
-
Touchscreen and hybrid control configurations
Each installation is tailored to the vessel — screen size, mounting position, visibility in sunlight, and how you sail all matter.
Proper Installation Matters on a Sailing Boat
Sailing electronics rely on accurate data and clean networks. A rushed or generic install can lead to unreliable wind readings, laggy displays, or systems that never quite feel right.
Our B&G installations focus on:
-
Correct network design (NMEA 2000)
-
Clean power supply and protection
-
Accurate sensor alignment and calibration
-
Logical screen layouts for sailing use
The result is a system that’s intuitive at sea and dependable when conditions turn average.
Local B&G Specialists – Port Macquarie NSW
Shotgun Marine is based in Port Macquarie, supporting sailors across the Mid North Coast NSW. Whether you’re fitting out a new yacht, upgrading an older system, or replacing a display that’s past its prime, we’ll help you get a B&G setup that suits your boat and how you sail.
Ongoing Support & System Expansion
Beyond installation, we also assist with:
-
Software updates and system tuning
-
Display upgrades and expansions
-
Integration with autopilots, wind and speed instruments
-
Fault finding and troubleshooting
If you want your B&G displays to work properly offshore — not just look good at the dock — we’ll make sure they’re set up the right way.